Diato Metal Flashing Deck Coatings

If you want to secure the perimeter of your deck, insuring a waterproof seal, you must dial in the metal edges.

Prestige Deck Coating knows how crucial properly installed diato metal flashing is to guarantee that your patio, balcony, or roof decks are waterproofed.

Stucco Siding Solution. For fully or partially enclosed decks and their adjoining walls, a special kind of metal flashing is used. In order to make the stucco wall flush with the flashing, diato metal flashing is employed (see picture to right). The stucco rests on the “v” angle and the remaining “L” flashing below is adhered to the deck to prepare for the metal lathe level. The stucco is then applied above the “v” and the deck coating installed underneath (see picture on left).

Quality Products. We at Prestige, secure the perimeter! We use 24 gauge bonderized metal flashing to insure strength and proper flex for your Orange County deck waterproofing foundations. The flashing is fitted tightly against the corners of the deck, then we generously apply industry grade caulking. We leave no corner uncaulked! Proper flashing installation is key to avoiding future deck leaks. Any holes in the metal are eliminated, and a snug fit into the corners is achieved.

Next, we adhere the diato metal flashing to the deck subfloor.

This is done in two ways. Caulking in applied behind and metal both on the subfloor and the wall. Second, the flashing is secured to the wall and subfloor with industry grade nails, one per six inches.  Each overlap on the metalwork and possible hole is sealed with caulking to insure waterproofing. Prestige Deck Coating leaves no hole unplugged, no corner exposed. Watertight Deck Coatings begin with proper metal installation.

Learn More About Us Here